Beechcraft A36 N2206L

Summary

On 24 June 2011 at about 01:45 local time, a Beechcraft A36 registered N2206L was involved in an accident near El Monte, California, United States. One person was on board and nobody was injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

24 June 2011 at 01:45

Classification

Accident

Location

El Monte, California, United States

Nearest airport

El Monte (EMT)

Coordinates

34.0861, -118.0347

Aircraft

Beechcraft A36

Registration

N2206L

Category

Airplane

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Chino → Camarillo

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

WPR11LA283

Nobody was injured.

The pilot's failure to maintain adequate airspeed during the forced landing, which resulted in an aerodynamic stall and hard landing. Contributing to the accident was the loss of engine power due to fuel starvation as a result of the pilot's improper fuel management.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The airplane had just undergone an avionics and flight instrument upgrade, completed on the morning of the accident. The pilot had intended to fly the airplane on a cross-country flight later in the day; however, subsequent flights revealed a discrepancy in the fuel pressure indication system and the airplane was returned to the maintenance facility, where the problems were resolved later that afternoon. This was to be the first time the pilot had flown the airplane solo since the system upgrade and, although he was instrument rated, he did not want to perform an instrument flight rules approach with the new avionics. He was now in a hurry to depart and performed a cursory preflight inspection. He could not recall if he checked the fuel tank quantity or used a checklist. Ten minutes into the flight the engine experienced a total loss of power. The pilot was convinced that the loss of power was caused by a maintenance oversight and did not switch fuel tanks, perform any troubleshooting steps, or review the emergency checklist. He performed a forced landing and inadvertently allowed the airplane to stall as it turned from the base leg to the final leg of the traffic pattern. The airplane landed hard, bending both wing spars, collapsing the right main landing gear, and separating the nose gear. A postaccident examination revealed that the left fuel tank was empty and that the fuel selector valve was set to the left tank. The fuel lines from the selector valve to the engine were devoid of fuel. Additionally, data extracted from the engine monitoring system revealed that the pilot departed with an almost full right tank but limited quantities of fuel in the left tank. The data indicated that he subsequently continued the flight until the fuel in the left tank became exhausted.

Quoted verbatim from the NTSB record.