Cessna 421C N421GP

Summary

On 31 August 2024 at about 17:30 local time, a Cessna 421C registered N421GP was involved in an accident near Fairview, Oregon, United States. 3 people were on board and 2 died. One person on the ground also died. The aircraft was substantially damaged. No probable cause has been published yet; this accident is still under investigation.

Date

31 August 2024 at 17:30

Classification

Accident

Location

Fairview, Oregon, United States

Nearest airport

Portland-Troutdale (TTD)

Coordinates

45.5435, -122.4380

Aircraft

Cessna 421C

Registration

N421GP

Category

Airplane

Year built

1977

Engines

2

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Troutdale → St. George

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

WPR24FA289

2 people died, including 1 on the ground.

The NTSB has not published a probable cause for this record. The investigation is still open; a final report usually follows one to two years after the accident.

Nothing about the cause is stated here that is not in the source record.

Read the full NTSB narrative

On August 31, 2024, about 1030 Pacific daylight time, a Cessna 421C, N421GP was destroyed when it was involved in an accident near Fairview, Oregon. The two pilots and one person on the ground were fatally injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight. Prior to departure, the pilot contacted the Troutdale Airport (TTD), Portland, Oregon, Air Traffic Control Tower (ATCT) and requested a visual flight rules departure from runway 25 and to remain within the airport traffic pattern. Review of recorded audio from the TTD ATCT and preliminary radar data revealed, at 1015, the airplane departed runway 25 and remained within the airport traffic pattern. A short time later, the controller queried the pilot about their intentions and stated that the airplane had flown above the airport traffic pattern altitude. The pilot confirmed that he intended to descend and remain in the airport traffic pattern. About 1 minute later, the controller queried the pilot a second time about his intentions, and the pilot responded that he was having “handling problems” followed by a partial radio transmission of “test flight; I can’t get this thing to.” The controller informed the pilot of converging traffic, instructed all other aircraft to standby, and issued a landing clearance to the pilot for runway 7. The controller subsequently queried the pilot and asked if they were able to land runway 7, to which the second pilot onboard responded, “we’re going to try, not sure.” The controller cleared the pilots to land any runway. No further radio transmissions were received from either pilot. Radar data showed that the airplane continued a left descending turn about 2 miles south of runway 25 until radar contact was lost. Recorded surveillance video footage from a camera located about 1.4 miles west-southwest of the runway 25 showed the accident airplane in a descending left turn with the landing gear extended. The airplane was on a southeasterly heading when the left wing struck high tension powerline wires. The airplane continued a southeast heading and impacted a mature oak tree and several residential structures, before postimpact fire ensued (figure 1). Figure 1: Accident site diagram Examination of the accident site revealed that the first identifiable point of contact was high-tension powerline wires about 110 ft in height. The debris path, which consisted of various airplane fragments, vegetation, and residential structure debris was about 703 ft in length and 477 ft wide, oriented on a heading of about 120° magnetic. All major structural components of the airplane were located throughout the debris path. The main wreckage was located within a residential structure. The wreckage was recovered to a secure location for further examination.

Quoted verbatim from the NTSB record.