Beechcraft 300 N217US

Summary

On 28 January 2021 at about 22:10 local time, a Beechcraft 300 registered N217US, operated by Carver Aero, was involved in an accident near Davenport, Iowa, United States. 2 people were on board and nobody was injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

28 January 2021 at 22:10

Classification

Accident

Location

Davenport, Iowa, United States

Nearest airport

Davenport (DVN)

Coordinates

41.6150, -90.5874

Aircraft

Beechcraft 300

Registration

N217US

Category

Airplane

Year built

2007

Engines

2

Operator

Carver Aero

Operating rule

Part 91: General Aviation

Purpose of flight

Instructional

Phase of flight

Not recorded

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

CEN21LA118

Nobody was injured.

The pilot’s failure to maintain directional control of the airplane, and the flight instructor’s inadequate oversight during a simulated engine out takeoff that resulted in a runway excursion and impact with a snowbank.  

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The pilot reported that during a simulated engine failure after decision speed (V1) takeoff, when the flight instructor reduced power on the airplane’s left engine during the takeoff roll, the airplane yawed left and veered toward the left edge of the runway where there was packed snow. The pilot reported that he applied right rudder and back pressure to rotate the airplane as the instructor pilot added right rudder with his set of rudder pedals. The instructor pilot reported he then attempted to restore left engine power as the airplane struck a snowbank on the edge of the runway. The airplane exited the left side of the runway and came to a stop. The airplane sustained substantial damage to the engine nacelles and the fuselage. The left engine was separated from the airplane and the right engine remained attached by skin. The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation. The instructor pilot reported that the flight’s purpose was for the pilot to conduct training in a twin-engine turboprop airplane, in preparation of an upcoming checkride. The plan was to simulate an engine failure during the takeoff roll, after passing takeoff decision speed (V1). He added that the plan was briefed the day prior and that the speeds were calculated and confirmed in the primary flight display (PFD) before the takeoff. The instructor pilot added that the runway was plowed 75 ft wide, with patches of packed snow near the edges.  

Quoted verbatim from the NTSB record.