Aviation Crash Map

Cessna 210 N9622T

26 October 2020 · Lubbock, Texas, United States · Fatal

Summary

On 26 October 2020 at about 20:58 local time, a Cessna 210 registered N9622T was involved in an accident near Lubbock, Texas, United States. One person was on board and one died. The aircraft was destroyed. The NTSB has published a probable cause for this accident; it is quoted in full below.

The record

Date
at 20:58
Classification
Accident
Location
Lubbock, Texas, United States
Nearest airport
Lubbock Preston Smith Internat (LBB)
Coordinates
33.5606, -101.8349
Aircraft
Cessna 210
Registration
N9622T
Category
Airplane
Year built
1960
Engines
1
Operator
Not recorded
Operating rule
Part 91: General Aviation
Purpose of flight
Personal
Phase of flight
Not recorded
Route
Belen → Corsicana
Aircraft damage
Destroyed
Weather
IMC
Light
Day
NTSB number
CEN21LA030

People

1 person died.

On board Died Serious Minor Uninjured
1 1 0 0 0

Probable cause

The pilot’s improper decision to fly into icing conditions with an airplane that was not equipped for icing, which led to structural icing and a subsequent loss of airplane control, and the pilot’s impairment from carbon monoxide poisoning due to a cracked heat exchanger. Contributing to the accident was the pilot’s self-induced pressure to complete the flight due to the incoming adverse weather conditions and the inadequate inspection of the cabin air heat exchanger.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The instrument-rated pilot had recently purchased the accident airplane, which was not equipped for icing conditions, and was in the process of flying it back to his home base. During the first flight after purchase, he flew at 11,000 ft and was reportedly sick during and after the flight. The pilot was sick and miserable all weekend with symptoms to include queasiness, fatigue, dizziness, and a general malaise. Following a discussion with friends regarding the forecast icing conditions along the route, the pilot departed for his destination airport. While en route, the pilot requested from air traffic control permission to divert to another airport “for fuel considerations” and stated that he had been flying in instrument meteorological conditions (IMC) for a while. The controller directed the pilot to an instrument approach fix but the pilot did not intercept the fix in time, so the controller rerouted him to the east to attempt the approach from the other side. At this time, the pilot would have been in icing conditions, but he did not express concern to the controller. During the approach, the pilot stated that he was experiencing “freezing rain”, but he continued the approach. Based on the airplane’s flightpath it is likely that the autopilot was engaged. The airplane’s flight track revealed that after the airplane passed the final approach fix the airspeed decreased below 50 knots and the airplane made a sharp left descending turn. The airplane impacted the ground behind a residence and a postimpact fire consumed a majority of the fuselage. Available weather data revealed that the airplane was in IMC, icing conditions, and likely encountered supercooled liquid droplets during the flight. These conditions would have created an environment favorable for structural icing. A review of the pilot’s flight planning account revealed that he had requested a weather briefing and would have had access to the most accurate and updated weather information. The pilot reported to his girlfriend that he “wanted to beat the weather” on the day of the accident. This statement is consistent with the pilot’s self-induced pressure to complete the flight due to the incoming adverse weather conditions. A postaccident examination of the airplane revealed thick chunks of ice on and near the leading edges of the airplane that were consistent with structural ice. While the pilot reported an autopilot issue, it is likely that the airplane had accumulated enough structural ice that the autopilot had difficulty functioning properly. Based on the evidence, the accident is consistent with the pilot not able to maintain control of the airplane. The examination revealed that the cabin air heat exchanger had preaccident cracking, which allowed exhausts gases to mix with the cabin air. Based on the condition of the exhaust system and heat exchanger, it is likely that the system was not adequately inspected during the last annual inspection. The pilot’s toxicology revealed an elevated carboxyhemoglobin level. It is likely that the pilot was impaired by the effects of carbon monoxide poisoning and this impairment contributed to the pilot’s overall confusion, willingness to continue flight in icing conditions, and to the circumstances of the accident.

Quoted verbatim from the NTSB record.

Other Cessna 210 accidents

Date Aircraft Location Operator Outcome Died
4 Oct 2020 Cessna 210
N9568X
Cedaredge, Colorado, United States Soaring 210 LLC Serious injuries -
26 Aug 2020 Cessna 210
N9540T
Chino, California, United States - No injuries -
5 Mar 2020 Cessna 210
N123CE
Needles, California, United States - Minor injuries -
19 Sep 2020 Cessna 210
ZS-KYD
Criterion, South Africa
no coordinates
- Unknown -
21 Dec 2020 Cessna 210L
N2246S
Midway, Georgia, United States - Fatal 1
13 Feb 2019 Cessna 210
PT-JIC
Belém City, State of Pará, Brazil Alex Sampaio Da Silva Fatal 1

All 2,022 records for this type

Other accidents in this area

Date Aircraft Location Operator Outcome Died
24 Jun 2020 Cessna 182
N958HP
Winfield, Texas, United States Brentco Aerial Patrol Serious injuries -
2 May 2020 MD Helicopters 369
N8375F
Houston, Texas, United States City Of Houston Fatal 1
28 Dec 2020 Piper PA-30
N1236
Navasota, Texas, United States - No injuries -
24 Jun 2020 CubCrafters CC19-180
N97LL
Fredericksburg, Texas, United States Kgnf, LLC No injuries -
27 Jun 2020 Piper PA32R
N315AM
Zavalla, Texas, United States - Fatal 1
6 Nov 2020 Cirrus SR20
N720TX
Fort Worth, Texas, United States Plane Smart! Aviation No injuries -

All 170,864 records in United States