Robinson R44 N3203D

Summary

On 7 July 2017 at about 21:00 local time, a Robinson R44 registered N3203D, operated by JMX Helicopters, was involved in an accident near Paoli, Indiana, United States. One person was on board and nobody was injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

7 July 2017 at 21:00

Classification

Accident

Location

Paoli, Indiana, United States

Coordinates

38.5856, -86.4647

Aircraft

Robinson R44

Registration

N3203D

Category

Helicopter

Year built

2005

Engines

1

Operator

JMX Helicopters

Operating rule

Part 137: Agricultural

Purpose of flight

Aerial Application

Phase of flight

Not recorded

Route

Sparta → Washington

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

GAA17CA401

Nobody was injured.

The pilot's decision to maneuver an overgross weight helicopter at a low altitude and airspeed with a gusting tailwind, which resulted in a high descent rate and collision with terrain. Contributing to the accident was the pilot's self-induced pressure to complete the operations due to a delay before the operations began.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

***This report was modified on June 13,2018. Please see the docket for this accident to view the original report.*** The helicopter pilot reported that he was performing an agricultural application flight and was in a hurry to spray the field because of a previous 3-hour delay caused by a broken fuel truck. The pilot reported that the weight of the helicopter was 40 lbs below the helicopter's maximum gross weight and that he "approached the field with the understanding that I was heavier, and it was hotter and more windy than I originally planned for." The pilot reported that the helicopter was headed south and that the wind was from the southwest about 15 knots. He made a low-altitude, low-airspeed, left turn to the north, and the helicopter entered a nose-low attitude and sank more rapidly than he anticipated. The pilot aborted the turn and chose to maintain a southeast heading to use the crosswind to avoid power lines. He attempted to arrest the sink rate by increasing the collective, but the low rotor rpm horn sounded. The helicopter impacted the ground, bounced, and then rolled onto its left side. The helicopter sustained substantial damage to the tailboom and the main rotor system. The nearest METAR was about 32 miles northwest of the accident site, and it reported, at the time of the accident, wind from 230° at 9 knots, gusting to 16 knots. The temperature was 88°F and the dew point was 20°F. The field elevation was 696 ft, and the density altitude was 2,786 ft. According to the Federal Aviation Administration (FAA) Helicopter Flying Handbook, FAA-8083-21A (pg. 2-4, para. 5), "turns in a helicopter increase the load factor exponentially, ultimately increasing the power requirement that is necessary to maintain the helicopter's altitude. Left pedal turns increase the quantity of anti-torque produced by the tail rotor, by demanding additional power from the 245-brake horsepower engine. Pilot flight control inputs demanding more power than the engine is capable of producing, with respect to the atmospheric conditions, adversely affects the helicopter's ability to sustain its altitude. Available engine power is directly correlated to main and tail rotor RPM. When the engine fails to produce the required power to sustain airspeed and altitude at high DA [descent altitude], the main rotor blades will exceed their critical angle of attack, consequently decreasing main rotor blade RPM." The pilot reported that there were no preaccident mechanical malfunctions or failures with the helicopter that would have precluded normal operation.    

Quoted verbatim from the NTSB record.