Thompson ANGEL HAWK II N335JT

Summary

On 9 June 2017 at about 13:30 local time, a Thompson ANGEL HAWK II registered N335JT was involved in an accident near Homer, Louisiana, United States. One person was on board and one was seriously injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

9 June 2017 at 13:30

Classification

Accident

Location

Homer, Louisiana, United States

Nearest airport

Homer Municipal Airport (5F4)

Coordinates

32.7897, -93.0064

Aircraft

Thompson ANGEL HAWK II

Registration

N335JT

Category

Airplane

Year built

2009

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Homer → Homer

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

CEN17LA228

1 person was seriously injured.

A total loss of engine power due to the engine’s unresolved high operating temperatures, which resulted in failure of the distributor rotor and drive shaft, and the pilot’s failure to maintain airspeed during the subsequent forced landing, which resulted in an aerodynamic stall and loss of control.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The private pilot reported that, during the accident flight, he planned to take off and circle the experimental, amateur-built airplane above the runway to check engine operation. Just after takeoff, the engine began sputtering. He made a left 180° turn to return to the runway and during the turn, the engine experienced a total loss of power. He stated that the airplane stalled when he was in the turn and he did not have enough time to recover before impacting the ground. The airplane had accumulated about 47 hours of run time and was in the initial flight test stage when the accident occurred. The pilot reported that he had been having trouble with increased cylinder head temperatures on the converted automotive engine. The engine had experienced a total loss of power during a previous flight, but the pilot was able to land the airplane without incident. Following that event, he replaced some ignition system components and adjusted the valves. He was then able to start the engine and reported that it "ran fine" during subsequent test runs. Postaccident examination of the airplane revealed that the fuel mixture was not adjustable in the cockpit. Examination of the engine revealed that there was melted plastic material inside the distributor rotor and the distributor drive shaft. The condition of the spark plugs was consistent with an overly lean fuel mixture and/or high temperature operation. It is likely that the melted distributor rotor was the result of the engine's high operating temperatures; the degradation of the distributor and its drive shaft would have resulted in a shift in ignition timing and a subsequent loss of engine power.

Quoted verbatim from the NTSB record.