Bell 206 N1076Y

Summary

On 14 June 2016 at about 22:50 local time, a Bell 206 registered N1076Y was involved in an accident near Bishop, California, United States. 3 people were on board and nobody was injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

14 June 2016 at 22:50

Classification

Accident

Location

Bishop, California, United States

Nearest airport

Bishop (BIH)

Coordinates

37.3278, -118.3972

Aircraft

Bell 206

Registration

N1076Y

Category

Helicopter

Year built

1980

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Corona → Mammoth Lakes

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

WPR16LA125

Nobody was injured.

The pilot’s improper preflight weather planning, fuel planning, and fuel management, which resulted in fuel starvation and a loss of engine power. Contributing to the severity of the accident was the pilot's initiation of the landing flare at a high altitude, which led to a subsequent hard landing.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The private pilot departed on a cross-country flight with two passengers onboard the helicopter, which had been filled with 110 gallons of fuel (88 gallons of which were in the aft tank) before departure. The pilot reported that, after encountering headwinds that were about 15 knots greater than anticipated and turbulence for more than 2 hours, he saw that the helicopter was low on fuel and decided to land at a nearby airport. He began a descent from 12,000 ft mean sea level (msl), but as he passed through 10,000 ft msl, he heard a "violent explosion in the engine compartment," followed by the illumination of the engine-out indication light. The pilot immediately initiated an autorotation and made two unsuccessful attempts to restart the engine during the descent. He flared the helicopter at 2,000 ft to avoid settling into a crater, and it subsequently impacted terrain hard. Paint transfer signatures on one of the main rotor blades indicated that they likely contacted and severed the tailboom during landing. The pilot stated that he did not pull the fuel pump circuit breakers before or during the accident flight; however, the unbreeched aft fuel tank was void of fuel when first responders examined it shortly after the accident, and the fuel pump circuit breakers were found in the "off" position. Further, operational tests of the fuel system and engine did not reveal any blockages or mechanical malfunctions. Fuel computations showed that the engine consumed 88 gallons of fuel, the quantity that would have been in the aft tank at the time of departure, and the pilot reported that he customarily disengages the fuel pumps after each flight. It is likely that the pilot's improper fuel management, possibly from departing with the fuel pumps in the "off" position, prevented fuel trapped in the forward tanks from reaching the engine and resulted in fuel starvation. The pilot had planned the flight around 15-knot winds despite multiple weather forecasts issued before his departure that indicated the presence of about 30-knot headwinds along his flight route. It is likely that the pilot's poor preflight weather and fuel planning resulted in greater-than-anticipated fuel consumption, which led to the low fuel state and the pilot's decision to divert to a closer airport. The pilot did not experience any control issues throughout the long autorotation from 10,000 ft, and weather reports indicated that he would not have encountered any visibility restrictions during the descent, so he should have had sufficient time to properly flare the helicopter and land. However, he chose to initiate a flare at 2,000 ft, which likely reduced the rotor rpm and led to hard impact with terrain.

Quoted verbatim from the NTSB record.