Quest KODIAC 100 N771RT

Summary

On 17 August 2015 at about 15:30 local time, a Quest KODIAC 100 registered N771RT, operated by Arrow West Aviation, was involved in an incident near Page, Arizona, United States. 6 people were on board and nobody was injured. The aircraft was slightly damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

17 August 2015 at 15:30

Classification

Incident

Location

Page, Arizona, United States

Coordinates

36.9261, -111.4483

Aircraft

Quest KODIAC 100

Registration

N771RT

Category

Airplane

Year built

2011

Engines

1

Operator

Arrow West Aviation

Operating rule

Part 135: Air Taxi & Commuter

Phase of flight

Not recorded

Route

Page → Moab

Aircraft damage

Minor

Weather

VMC

Light

Day

NTSB number

WPR15IA244

Nobody was injured.

The pilot's inadvertent failure to engage the seat in the locked position before takeoff, which resulted in the seat sliding back during the takeoff roll and a subsequent loss of directional control. Contributing to the incident was the seat locking mechanism's design of limited feedback, which made it difficult to verify if the seat stops were positively engaged.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

During the takeoff roll on the non-scheduled passenger flight, the pilot's seat slid back abruptly to the full-aft position. Because his right hand was positioned on the throttle for takeoff, the pilot inadvertently retarded the throttle to the idle position as the seat slid aft. The airplane began to veer off the runway and collided with a wire fence. The seat was designed with two latches, one located on each of the right and left sides of the seat, which are lifted to enable the seat to move along the track. The seat track consisted of two metal rails that were affixed to the floor along the airplane's longitudinal axis. The rails had numerous circular receptacles where the seat stop would engage when the seat was locked into position. In order to move the seat, a handle on the latches would be raised upward, the seat stops would both raise, and the pilot could move the seat. The latch gives no positive indication (feel) when effectively raised or lowered. The before takeoff checklist contained in the pilot's operating handbook included the item, "seat locked and secure." An examination of the pilot's seat revealed that both the left and the right aft locking foot caps were damaged. The locking foot caps comprise a four-pronged housing that encages the seat stop mechanisms. It is likely that the caps were damaged during maintenance and/or installation. Instead of completely removing the seat from the airplane, the technician likely pushed the seat all the way aft on the tracks. Investigators attempted to replicate the incident scenario and were successful only when applying an extreme side load or manipulating the latch. The lack of positive response in the latch of the stops being engaged in the tracks made it difficult to verify if the seat stops were positively engaged before the takeoff attempt. It is unknown if the damaged locking foot caps contributed to the incident.

Quoted verbatim from the NTSB record.