Czech Sport Aircraft A S SPORTCRUISER N162US

Summary

On 4 May 2014 at about 13:30 local time, a Czech Sport Aircraft A S SPORTCRUISER registered N162US was involved in an accident near Advance, North Carolina, United States. One person was on board and one was seriously injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

4 May 2014 at 13:30

Classification

Accident

Location

Advance, North Carolina, United States

Coordinates

35.9878, -80.4889

Aircraft

Czech Sport Aircraft A S SPORTCRUISER

Registration

N162US

Category

Airplane

Year built

2011

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Personal

Phase of flight

Not recorded

Route

Mocksville → Mocksville

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

ERA14LA219

1 person was seriously injured.

The pilot’s failure to apply carburetor heat during a descent with reduced engine power while operating in conditions conducive to carburetor icing, which resulted in a total loss of engine power.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

According to the pilot, about 45 minutes into the local flight and after reducing engine power for the descent, the engine rpm began to decrease. She applied carburetor heat in an attempt to regain full engine power; however, the engine rpm continued to decrease, and the engine then lost total power. She unsuccessfully attempted to restart the engine, performed the emergency engine shutdown procedures, and then chose to land the airplane in a field, during which it sustained substantial damage to the firewall, fuselage, and right wing. A postaccident examination of the airframe revealed no anomalies that would have precluded normal operation. The engine was test run and examined about 4 months after the accident. The engine was initially test run using alternate fuel with no anomalies noted. The engine was then test run using fuel found in the left wing tank. During that test run, the engine hesitated, but it did not lose total power. The fuel recovered from the airplane was tested, and it did not meet the specification limits for automotive gas, aviation gas, or UL82 aviation gas; however, it did exhibit characteristics of evaporated automotive gas. Although a white powdery substance was found in the carburetor and the fuel did not meet specifications, due to the amount of time that passed between the accident and the engine examination, it could not be determined whether the powdery substance was in the carburetor, or what the fuel condition was, when the engine lost power. Weather conditions at the time of the accident were conducive to the accumulation of serious carburetor icing at glide power, and carburetor icing is more likely to form when an engine is operating on automotive gas. In addition, the Pilot's Operating Handbook noted that carburetor heat should be used during descents. Therefore, it is likely that the pilot's delayed application of carburetor heat during the descent resulted in a total loss of engine power due to carburetor icing.

Quoted verbatim from the NTSB record.