Agusta A119 N207CF

Summary

On 20 October 2012 at about 05:15 local time, a Agusta A119 registered N207CF, operated by TriState CareFlight Inc., was involved in an incident near Dolan Springs, Arizona, United States. 3 people were on board and nobody was injured. The aircraft was slightly damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

20 October 2012 at 05:15

Classification

Incident

Location

Dolan Springs, Arizona, United States

Coordinates

35.8014, -114.5361

Aircraft

Agusta A119

Registration

N207CF

Category

Helicopter

Year built

2000

Engines

1

Operator

TriState CareFlight Inc.

Operating rule

Part 91: General Aviation

Purpose of flight

Other Work Use

Phase of flight

Not recorded

Route

Kingman → Kingman

Aircraft damage

Minor

Weather

VMC

Light

Night/Dark

NTSB number

WPR13IA020

Nobody was injured.

Insufficient clearance between a truck and the main rotor blades of a helicopter on the ground with the engine running because of the lack of on-scene coordination between the agencies that responded to and were tasked with managing the vehicle accident site.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

After arriving at the site of the vehicle accident, command post personnel advised the emergency medical services (EMS) flight crew that they did not have a patient for them and that the flight crew was authorized to depart. An EMS crewmember reported that he requested that the vehicle traffic, which had been stopped as a result of the traffic accident, be held until they departed. The on-scene fire department captain, who was in charge of directing the arriving and departing aircraft and had left the area before the helicopter departed, also requested before his departure that ground traffic be held until the helicopter had lifted off. However, on-scene law enforcement personnel who were controlling the traffic stated that they had not received either request. During the helicopter's engine startup, which the operator authorized the pilot to perform whether ground traffic was moving or not, one flight crewmember was positioned outside of the helicopter directing ground traffic around the helicopter's right side. The crewmember subsequently boarded the helicopter, and, shortly after, a truck collided with the tips of the helicopter's main rotor blades, which resulted in significant damage to the truck and minor damage to the helicopter's main rotor blades. If standard traffic incident management procedures had been strictly adhered to by the agencies involved, it is likely that this event would not have occurred.

Quoted verbatim from the NTSB record.