Schweizer 269C-1 N247FG

Summary

On 21 June 2010 at about 18:00 local time, a Schweizer 269C-1 registered N247FG, operated by WNC Aviation, was involved in an accident near Asheville, North Carolina, United States. 2 people were on board and nobody was injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

21 June 2010 at 18:00

Classification

Accident

Location

Asheville, North Carolina, United States

Coordinates

35.4361, -82.5419

Aircraft

Schweizer 269C-1

Registration

N247FG

Category

Helicopter

Engines

1

Operator

WNC Aviation

Operating rule

Part 91: General Aviation

Purpose of flight

Other Work Use

Phase of flight

Not recorded

Route

Morganton → Asheville

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

ERA10LA323

Nobody was injured.

The pilot's failure to maintain forward airspeed, which resulted in a settling with power encounter.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

The pilot departed for a local photo documentary flight with the helicopter about 80 pounds under gross weight. About 20 minutes after departure, the passenger spotted an area of invasive plant species which he wanted to film. The pilot then performed a 360-degree turn and approached the area in straight and level flight, between 30-40 knots to maintain translational lift. The passenger reported that they were closer than usual as they lined up for the approach. The pilot heard a pitch change in the engine and lowered the collective slightly and increased the throttle; however, the helicopter began to descend. Shortly after, the pilot stated, "she’s settling," and the passenger noted they were nearing the top of the trees going about 5-10 mph. The passenger reported that the helicopter came to a very slow stop above the trees and then felt like they were slowly sinking. He stated the engine felt like it was bogging down just prior to the helicopter beginning a slow, straight descent until the rotor blades impacted trees and the helicopter dropped to the ground. The engine was test run on the helicopter and no preimpact mechanical anomalies were noted. Examination of a videotape taken by the passenger during the accident sequence revealed that the engine continued to run, with no discernible engine anomalies prior to the accident. According to the Federal Aviation Administration’s Rotorcraft Flying Handbook, "settling with power" defines when the helicopter keeps settling even though full engine power is applied. Among the conditions listed that were conducive to settling with power were: attempting to hover out of ground effect without maintaining precise altitude control, or downwind or steep power approaches at low forward airspeed.

Quoted verbatim from the NTSB record.