Bell 407 N407GB

Summary

On 22 December 2008 at about 21:04 local time, a Bell 407 registered N407GB, operated by JBI Helicopter Services, Inc., was involved in an accident near Bow, New Hampshire, United States. One person was on board and one was seriously injured. The aircraft was substantially damaged. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

22 December 2008 at 21:04

Classification

Accident

Location

Bow, New Hampshire, United States

Coordinates

43.1475, -71.5181

Aircraft

Bell 407

Registration

N407GB

Category

Helicopter

Engines

1

Operator

JBI Helicopter Services, Inc.

Operating rule

Part 91: General Aviation

Purpose of flight

Positioning

Phase of flight

Not recorded

Route

Danielson → Pembroke

Aircraft damage

Substantial

Weather

VMC

Light

Day

NTSB number

ERA09LA105

1 person was seriously injured.

An interruption of fuel flow for undetermined reasons, which resulted in an engine flameout.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

Two days before the accident, the helicopter landed at an airport due to en route snow. On the day of the accident, company personnel spent about 5 hours cleaning and deicing it. The pilot subsequently conducted multiple ground and air taxi runs before departing toward his home heliport. About 45 minutes into the flight, when the helicopter was about 900 feet over tree-covered terrain, the engine lost power. The pilot then performed an approximately 180-degree autorotation to a curved street. The helicopter landed hard and sustained substantial damage to the fuselage. Prior to the loss of engine power, the pilot did not observe any caution or warning lights, and the FADEC (Full Authority Digital Engine Control) remained in the automatic mode. The pilot also noted no unusual noises or yawing of the helicopter prior to the loss of engine power. A subsequent download of the helicopter's incident recorder revealed "Engine Flameout," "Nr Droop," and "Ng Exceedance Low" faults. It also indicated that when the flameout detection occurred, "Fuel Enable" and "Auto Relight" functions became active. Subsequent examinations of the airframe, including the fuel supply system, revealed no anomalies that would have resulted in a flameout. The electronic control unit was downloaded, with no faults noted. The electronic control unit and the hydro mechanical unit were examined with no anomalies noted. The engine was mounted in a test cell and successfully run with no discrepancies noted. During a later engine test run, the fuel was intentionally shut off through a solenoid, and except for rotor rpm, the incident recorder indicated the same faults as noted in the accident sequence, confirming that the loss of engine power likely occurred due to an interruption of fuel flow for undetermined reasons.

Quoted verbatim from the NTSB record.