Eurocopter AS-350-B2 N513TS

Summary

On 1 July 2004 at about 22:00 local time, a Eurocopter AS-350-B2 registered N513TS was involved in an accident near Scottsdale, Arizona, United States. 2 people were on board and 2 had minor injuries. The aircraft was destroyed. The NTSB has published a probable cause for this accident; it is quoted in full below.

Date

1 July 2004 at 22:00

Classification

Accident

Location

Scottsdale, Arizona, United States

Nearest airport

Scottsdale (KSDL)

Coordinates

33.7006, -111.9419

Aircraft

Eurocopter AS-350-B2

Registration

N513TS

Category

Helicopter

Engines

1

Operator

Not recorded

Operating rule

Part 91: General Aviation

Purpose of flight

Flight Test

Phase of flight

Not recorded

Route

Scottsdale → Unknown

Aircraft damage

Destroyed

Weather

VMC

Light

Day

NTSB number

LAX04LA254

2 people had minor injuries.

Inadvertent in-flight engagement of the collective down lock, which resulted in an uncontrolled descent and ground impact. The collective down lock engagement was caused by the improper installation and/or adjustment of the collective locking system, which reduced the clearance between the locking plate and the collective control. A factor was the pilot’s decision to embark on a maintenance test flight after encountering difficulty disengaging the collective lock release during previous hover tests.

Quoted verbatim from the NTSB record. This site does not paraphrase or interpret it.

Read the full NTSB narrative

While performing a maintenance check flight, the collective down lock engaged, which resulted in an uncontrolled descent and collision with terrain. The pilot and a mechanic were to fly a maintenance flight check of the engine and perform a rotor track and balance. He entered a descent at approximately 1,200 feet above ground level (agl) and prepared to level off at approximately 700 feet agl. When he tried to pull up on the collective, the collective would not move and was observed latched by the collective down lock. He and the mechanic tried to unlatch the collective from the down lock, but they did not have enough time before he had to flare the helicopter for landing. With the collective stuck in flat pitch, they landed hard and with forward speed. The flight crew evacuated the helicopter once it had come to rest. An ensuing post accident fire destroyed the helicopter. A new after market avionics control panel had been installed and the collective down lock, which is secured to the panel, was adjusted prior to the flight. The down lock attaches to the lower section of avionics panel. When the collective is lowered to the lower pitch stop the clearance between the collective and the down lock is about 0.16 inches. The down lock is a flexible plate that is free to vibrate with the helicopter's normal rhythms. In the original factory installation, the clearance between the down lock and the collective is 0.3 inches. This is the second known accident where the collective lock has inadvertently engaged in flight with this particular after market avionics panel installed. The manufacturer of the aftermarket avionics panel provided installation information indicating that maintenance personnel must bend the collective locking plate such that the locking plate will spring away from the collective lock button. Examination of the accident aircraft’s locking plate indicated that the locking plate bend was likely reversed, allowing the locking plate to spring toward the lock button.

Quoted verbatim from the NTSB record.